On VitaNova, we upgraded the motion system with velocity-based smoothing — smoother movements regardless of distance — and tested high-end helicopter servos. Turns out they only rotate 100°, so we’re going back to a 180° version for now while working on a full redesign of the neck using stepper motors. Cooling also got a big boost: new resin-printed heat-resistant compute case, custom airflow routing, and sound dampening brought CPU temps down while keeping the mic signal clean
Meanwhile, WAI-LLE got its power system rebuilt from scratch. It now runs cleanly off a single 220v input with dual buck converters and electrolytics — no more flickering. We also tested and mounted dual SPI square displays after solving mislabeled PCB pins and frying one screen during a resistor swap (RIP 🫡). Good news: backups arrived and both screens now run together beautifully. A new faceplate is coming next. V0.2 is basically ready for testing
Big week. Lots learned. More to come.
Printing torso V9 with outside fan casing on the back



Printing new compute case with a resin 3D printer so it will be heat resistant



Testing new high power servo for neck rotation

Brainstorming ideas for better neck rotation and tilt mechanisms

